Before Proceeding - Follett Horizon Elite Chewblet HCC710AJS Installation Instructions Manual

Install the docking assembly.

BEFORE PROCEEDING

Prior to installing the docking assembly, ensure that the drain fitting
is oriented (right or left) correctly for your installation. An optional
straight drain fitting is also supplied. You may need to remove the
back panel of the docking assembly in order to re-orient or change
the drain fitting. Replace back panel prior to mounting the docking
assembly.
Wall bracket accessory
• Mount docking assembly to wall bracket
accessory
4.1
Undercounter installation requirements
DOCKING STATION
• Position and screw docking assembly to the bottom of counter inside of access panel/door
1010/1410: 2.25" (57 mm) from the front edge of asembly
710: 3.25" (82.55 mm) from the front edge of the cross brace
• The mounting surface for the docking assembly must be solid.
Do not mount directly onto runners or channels.
• There must be no lip or edge that would hinder the ice machine from sliding in or out of the
docking station ➋
INTAKE AND EXHAUST GRILLE PLACEMENT: Air-cooled models only
• Position the intake grille cutout in the access panel/door
Note: Ice machine must be aligned with cutout and inside of access panel to provide a tight
seal and prevent recirculation of hot exhaust air.
• Left edge of cutout from the left side of the ice machine
1010/1410: 2.25" (57 mm)
710: 2" (51 mm)
• Bottom edge of cutout should be 2" (51 mm) from the bottom of the ice machine
• Position supplied exhaust grille at least 18" (458mm) away from intake grille
Where possible, install exhaust grille to the rear or side of the base cabinet.
• If not using supplied grille, air circulation requirements below must be met:
1010/1410: 250 sq. in (1613 sq cm) intake/exhaust air
710: 160 sq. in (1032 sq cm) intake/exhaust air
DROP-IN • RIDE Technology
• Mount docking assembly to machine
stand accessory
self-contained
Docking assembly
Machine stand accessory
➌
➎
4
➊
➍
.
7