Cleaning - Permobil Compass Power Mount Operation Manual

Cleaning

WARNINGS:
- Follow all manufacturer bleach container and germicidal disinfectant safety guidelines.
- Before transferring to a new user, the product must be completely cleaned and disinfected.
- Periodically, check the cover and components for damage and wear, and replace if necessary. Some wear with regular use is
expected.
CAUTION: Frequent heat drying and bleaching will cause fabric to break down. Air drying and cleaning without bleach are
recommended whenever possible to help extend the life of the cover.
SURFACE CLEANING AND DISINFECTING COMFORT-TEK FABRIC ONLY
Spray with common household or commercial antibacterial cleansers or disinfectants. Wipe with a damp,
water-only cloth after disinfecting. Let dry completely before use.
CAUTIONS:
- Remove hook fastener pieces from the cover before cleaning and disinfecting. Hook fasteners may snag the fabric, causing
changes in the appearance (but not the effectiveness) of the fabric.
- Before cleaning or disinfecting, remove the cover from the support pad and hardware (including foam and moldable stays if
applicable).
Cleaning - All Fabrics: When possible, hand wash in warm water with mild soap, rinse
thoroughly with clean water, and air dry (let dry completely before use). Or machine wash
using common laundry detergent and tumble dry low. DO NOT steam clean or autoclave. DO
NOT iron.
Disinfecting - All Fabrics: Follow the cleaning instructions. Hand wash in warm
water, using 1 part household liquid bleach per 9 parts warm 40°C/104°F water. Rinse
thoroughly with clean water. Let dry completely before use. Or machine wash in hot
water and bleach. Tumble dry low.
WARNINGS: DO NOT use contaminated foam with multiple users. Disinfectants are NOT effective on porous surfaces
such as foam. Replacement foam components may be purchased separately.
CAUTIONS: DO NOT submerge the foam in any liquid, including water. The foam should not be exposed to light for any
extended period of time. Light will cause discoloration of the foam.
Note: Discoloration will not affect the functional features. There is no need to attempt to "clean" discoloration caused by light
exposure.
Soiled foams should be replaced. Remove the cover. Wipe lightly with a damp cloth. DO NOT use
soap. Let dry completely before replacing the cover.
CAUTION: Before cleaning or disinfecting, remove the cover support pad from the hardware.
Cleaning: Hand wash in warm (40°C/104°F) water with soap and a sponge. Rinse with clean water and wipe
dry with a clean cloth. Dry completely before use.
Disinfecting: Wipe gently with a cloth dampened with a household disinfectant. Rinse with clean, warm
water. Wipe dry with a clean cloth. Dry completely before use.
Care Symbols
Wipe with a damp cloth.
Hand wash warm.
Machine wash warm,
40C
normal.
Compass Power Mount Hardware Operation Manual
CLEANING AND DISINFECTING ALL FABRICS
SUPPORT FOAM
CLEANING AND DISINFECTING HARDWARE
Hand wash.
Tumble dry low.
Machine wash hot, normal, at the temperature shown.
60C
Dry flat.
Do not tumble dry.
17
OR
40C
OR
40C
Line dry.
Bleach (1 part bleach: 9
parts water).