Location Selection - Zoeller QWIK JON PREMIER 201 Installation Instructions Manual

Hide thumbs Also See for QWIK JON PREMIER 201:

Installation instructions manual (40 pages)

Quick reference manual (2 pages)

Notice to installer (26 pages)

Table of Contents

QWIK JON

STEP 1

Plan your new installation carefully.

Floor: The

floor

should be structurally sound and level within 3 mm (1/8"). If the

is not level, use hydraulic cement or similar material to level to the floor.

Water: A water supply will be needed to operate the toilet. Usually a DN15 (1/2")

line with a shut-off valve is

Electrical: A receptacle of the appropriate voltage will be needed to supply electrical

power to the pump.

Sewage: Access to a sewage line is required. The Qwik Jon

a DN25 (1") (or DN20 [3/4"]

connect to an existing sewage line. A ball or gate valve should

discharge line.

Vent: Access to a vent pipe is required in some markets. The use of a mechanical

vent system is NOT recommended as the toilet will not

Please replace the carbon filter periodically.

Optional

carbon filter vent:

of a mechanical vent system is NOT recommended as the toilet will not

NOTE: If a built-in installation is to be used, locate the pump unit in an area that

will allow access to the pump and switch.

Always disconnect power source

before a�emp�ng to install, service,

or maintain the system.

Never handle a pump with wet

hands or when standing on wet

or damp surface or in water. Fatal

electrical shock could occur.

STEP 2

Do not use wooden shims to level the pump unit.

Ensure that nails, screws or other sharp objects do not puncture the pump unit.

Level the pump unit to within

3mm

PREMIER QUICK REFERENCE GUIDE