Indoor Unit (Compact Wall Mounted Type) - Fujitsu Airstage V-II Design & Technical Data

SETTING UP EACH INDOOR UNIT
„ „
01-01 01-02
RESET THE POWER AFTER SETTING UP ADDRESS OF ALL
„ „
INDOOR UNITS
Important
● If the reset is not performed, address can not be read in normally6
● After all the addresses have been set, the circuit breaker needs to be switched off
for at least 2 minutes6
After the 2 minutes has passed, power can be restored6
● The set address is stored in the PCB and will remain in memory even when the
power is turned off6
However setting address is effective after power reset6
Record the address set in the indoor unit on a label, etc., and affix the label to the
unit so it can be used for after6sales service operations6
* Address 0 setting will not indicate TIMER LAMP and FILTER LAMP.
* Once the "RESET" button is pressed on the remote controller, the OPERATION MODE will be
set in the "AUTO MODE".
Please adjust the OPERATION MODE to either "COOLING" or "HEATING" before trying to
operate the air conditioner.
* Note : If CUSTOM CODE is set to anything other than "A" ,the remote control must be set
accordingly to the INDOOR UNIT setting.
01-03
Repeat steps (1) through to (25). Steps (1) through to (6)
and (21) to (25) only need to carried out if the custom
code is different to the factory setting of "A".
- (06 - 84) -