Indoor Unit (Compact Cassette Type And Cassette Type) - Fujitsu Airstage V-II Design & Technical Data

COMPLETION OF ADDRESS SETTING MODE
„ „
(21) Press and hold the "MANUAL/AUTO
button for 3 seconds.
MANUAL AUTO
IR RECEIVER UNIT
Each LED light brightness is darkening though the content

of the display doesn't change.
The address setting signal is not received after switched address setting completion mode. (Pi Pi Pi Pi Pi)
 „
Press the "MANUAL/AUTO
 „
setting mode.
RECONFIRMATION OF ADDRESS SETTING
„ „
(23) Press and hold the "FAN" and the " SET
TEMP. " buttons. Whilst holding these 2
p
buttons, press the "RESET" button.
FAN
SET TEMP. ( )
RESET
INDOOR UNIT ADDRESS SETTING
z „
(24) Make sure the function number is "01"
Refer to (8)
Press the "TIMER set (-)" button.
"TIMER set (-)"
REFRIGERANT CIRCUIT ADDRESS SETTING
z „
(25) Make sure the function number is "02"
Refer to (15)
Press the "TIMER set (-)" button.
"TIMER set (-)"
" (22) Press the "RESET" button.
Pi Pi Pi
MANUAL
AUTO
" button again for 3 sec to return to if required to return the address
Function setting
mode display
(Example) ADDRESS : 34
OPERATION LAMP
(GREEN)
TIMER LAMP
(ORANGE)
FILTER LAMP
(RED)
(Example) ADDRESS : 25
OPERATION LAMP
(GREEN)
TIMER LAMP
(ORANGE)
FILTER LAMP
(RED)
- (06 - 83) -
After pressing the RESET
button, please set the custom
code again if b,c,d setting.
RESET
0.5sec ON / 0.5sec OFF
3 times 1 - 10 sec
0.5sec ON / 0.5sec OFF
4 times
1 - 10 sec
1sec ON / 1sec OFF
0.5sec ON / 0.5sec OFF
2 times 1 - 10 sec
0.5sec ON / 0.5sec OFF
1 - 10 sec
5 times