NuTone IM-5006 Series Installation Instructions Manual page 8

INSTALLATION ( Continued )
Securing the Master Panel
1. Check all wiring connections to make sure they are
complete and correct.
2. Check to make sure antenna connection is secure.
3. Position the Master Panel over rough-in frame and align
screw holes in Master Panel with rough-in frame.
Dress the wires carefully on both sides of the panel so
as to prevent them from being pinched when closing the
panel.
4. Secure the Master Panel to rough-in with four (4) screws
provided.
General Intercom Operation
NOTE: Refer to the homeowner's manual for complete
information on the intercom operation of this system.
1. When an intercom call is initiated, a CALL TONE will be
heard at the station from which the call is placed as well as
the station that is being called. NOTE: If one of these
stations is a door speaker, a CALL TONE will not be
heard at that location.
2. The station that is being called will be in the "hands-free"
mode.
3. The intercom volume is adjusted by using the intercom
volume UP-DOWN keys and may only be adjusted during
an intercom call. The radio volume cannot be adjusted at a
station that is participating in an intercom call.
4. When an intercom call is in progress, the BUSY light will
be lit at stations not participating in the communication. An
intercom call cannot be initiated from a station when the
busy light is lit.
8
FIGURE 21