Table of Contents
Advertisement
INSTALLATION ( Continued )
Attaching the Master Panel
to the Rough-in
Refer to Figure 8.
1. Use two No. 6 x 3/8" screws to attach mounting brackets
to the top and bottom of rough-in frame. Make sure
brackets are flush to wall or rough-in.
Refer to Figures 9 & 10.
2. For rough-in frames which are recessed into the wall
opening. Insert two shoulder screws (provided) into the
front two holes in the rough-in frame. For rough-in
frames which are mounted flush with the wall. Insert
two shoulder screws (provided) into the back two holes in
the rough-in frame.
Refer to Figure 11.
3. Attach master panel to rough-in frame by placing keyhole
slots in both mounting hinges over screw heads in
rough-in frame.
Refer to Figure 12.
4. Slide master panel to the right, then forward until panel is
flush with the wall.
Refer to Figure 8.
5. Attach support strap to rough-in by placing hook into hole
in rear flange of rough-in frame.
BACK HOLE - FOR
FLUSH MOUNTED
ROUGH-IN
FRONT HOLE -
FOR RECESSED
ROUGH-IN
FIGURE 9
Connecting the Transformers
WARNING: Before any connections are made to the
transformers, power must be disconnected at the main circuit
breaker.
1. The transformer's primary leads should already be
connected to the 120vAC house supply wires.
2. Two (2) sets of low-voltage supply leads are located
in the bottom center section of the master unit. Connect
one pair of supply leads to each transformer located in
the bottom of the Rough-In.
3. Dress the wires and secure the box with two (2) screws for
each box as illustrated in the rough-in installation
instructions.
4. Connect the ground wires from the master unit to one of
the transformer boxes mounting screws.
5. For installation of transformer, refer to manual for IR-510
Rough-In Frame.
MOUNTING
BRACKETS
(4)
FIGURE 10
4
FIGURE 11
GROUND
WIRE
FIGURE 8
FIGURE 12
LOW VOLTAGE
AC SUPPLY
LEADS
FIGURE 13
Advertisement
Table of Contents
