Download Print this page
Hide thumbs Also See for IM-3204:

Advertisement

RADIO/INTERCOM
SYSTEM
Two Year Limited Warranty
WARRANTY OWNER: NuTone warrants to the original consumer purchaser of its products that
such products will be free from defects in materials or workmanship for a period of two (2)) years
from the date of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR
MODEL IM-3204
IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE.
During this two year period, NuTone will, at its option, repair or replace, without charge, any
product or part which is found to be defective under normal use and service. THIS WARRANTY
DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS OR TUBES. This warranty does not
cover (a) normal maintenance and service or (b) any products or parts which have been subject to
misuse, negligence, accident, improper maintenance or repair (other than by NuTone), faulty
installation or installation contrary to recommended installation instructions.
The duration of any implied warranty is limited to the two year period as specified for the express
warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above
limitation may not apply to you.
NUTONE'S OBLIGATION TO REPAIR OR REPLACE, AT NUTONE'S OPTION, SHALL BE THE
PURCHASER'S SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY. NUTONE SHALL
NOT BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT
OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. Some states do not allow
the exclusion or limitation of incidental or consequential damages, so the above limitation or
exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have
other rights, which vary from state to state. This warranty supersedes all prior warranties.
WARRANTY SERVICE: To qualify for warranty service, you must (a) notify NuTone at the
address stated below or telephone 1/800-543-8687, (b) give the model number and part
identification and (c) describe the nature of any defect in the product or part. At the time of
requesting warranty service, you must present evidence of the original purchase date.
Date of Installation
Builder or Installer
Model No. and Product Description
®
IF YOU NEED ASSISTANCE OR SERVICE:
For the location of your nearest NuTone Independent Authorized Service Center:
Residents of the contiguous United States Dial Free 1-800-543-8687
Please be prepared to provide:
Product model number • Date and Proof of purchase • The nature of the difficulty
Residents of Alaska or Hawaii should write to: NuTone Inc. Attn: Department of National Field
Service, 4820 Red Bank Road, Cincinnati Ohio 45227-1599.
Residents of Canada should write to: Broan-NuTone Canada, 1140 Tristar Drive,
Mississauga, Ontario, Canada L5T 1H9.
Rev. 03/2001
HOMEOWNER'S
OPERATING
INSTRUCTIONS
Product specifications subject to change without notice.
Printed in China, Rev. 10/2001, Part No. 87840

Advertisement

loading

Summary of Contents for NuTone IM-3204

  • Page 1 IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. During this two year period, NuTone will, at its option, repair or replace, without charge, any product or part which is found to be defective under normal use and service. THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS OR TUBES.
  • Page 2: Resetting The Microprocessor

    No others have the same serial number as yours. You should record the number and other vital information here and retain this book as a permanent record of your purchase to aid identification in case of theft. Date of Purchase Dealer Purchased from Dealer’s Address Dealer’s Phone No. Model No. IM-3204...
  • Page 3 Illustration of Model IM-3204 ........
  • Page 4: Intercom Operation

    Station Status Switches The STATION STATUS switches set the operation of each station in the system. Each station may be set at one of the three following modes: 1. RADIO/ IP- Stations set to this mode will receive all program audio, intercom audio and monitor audio (provided that the station’s volume control is properly set).
  • Page 5: Setting Program Audio Controls

    Program Audio Controls The following controls allow the user to adjust the level and tone of the program audio. 1. MASTER VOLUME- This control adjusts the audio level at the master station. 2. REMOTE VOLUME- This control adjusts the audio level at the remote station. 3.
  • Page 6: Audio Source Selection

    Audio Source Selection RECALLING FREQUENCIES 1. Select AM or FM mode. INITIAL OPERATION OF THE SYSTEM REQUIRES: 2. Press the MEMORY RECALL key until desired memory channel is shown in the LCD display. • All STATION STATUS switches set to RADIO/ IP mode. CONTROLLING THE RADIO FROM REMOTE SPEAKERS •...