NuTone IMA-4406 Series Operating Instructions Manual

NuTone IMA-4406 Series Operating Instructions Manual

Cd/radio
Hide thumbs Also See for IMA-4406 Series:

Advertisement

CD/ RADIO
INTERCOM SYSTEM
Two Year Limited Warranty
WARRANTY OWNER: NuTone warrants to the original consumer purchaser of its products that
such products will be free from defects in materials or workmanship for a period of two (2)) years
MODEL IMA-4406 SERIES
from the date of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR
IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE.
During this two year period, NuTone will, at its option, repair or replace, without charge, any
product or part which is found to be defective under normal use and service. THIS WARRANTY
DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS OR TUBES. This warranty does not
cover (a) normal maintenance and service or (b) any products or parts which have been subject to
misuse, negligence, accident, improper maintenance or repair (other than by NuTone), faulty
installation or installation contrary to recommended installation instructions.
The duration of any implied warranty is limited to the two year period as specified for the express
warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above
limitation may not apply to you.
NUTONE'S OBLIGATION TO REPAIR OR REPLACE, AT NUTONE'S OPTION, SHALL BE THE
PURCHASER'S SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY. NUTONE SHALL
NOT BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT
OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. Some states do not allow
the exclusion or limitation of incidental or consequential damages, so the above limitation or
exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have
other rights, which vary from state to state. This warranty supersedes all prior warranties.
WARRANTY SERVICE: To qualify for warranty service, you must (a) notify NuTone at the
address stated below or telephone 1/800-543-8687, (b) give the model number and part
identification and (c) describe the nature of any defect in the product or part. At the time of
requesting warranty service, you must present evidence of the original purchase date.
Date of Installation
Builder or Installer
Model No. and Product Description
IF YOU NEED ASSISTANCE OR SERVICE:
For the location of your nearest NuTone Independent Authorized Service Center:
Residents of the contiguous United States Dial Free 1-800-543-8687
Please be prepared to provide:
Product model number • Date and Proof of purchase • The nature of the difficulty
Residents of Alaska or Hawaii should write to: NuTone Inc. Attn: Department of National Field
Service, 4820 Red Bank Road, Cincinnati Ohio 45227-1599.
Residents of Canada should write to: Broan-NuTone Canada, 1140 Tristar Drive,
Mississauga, Ontario, Canada L5T 1H9.
Rev. 03/2001
HOMEOWNERS

OPERATING INSTRUCTIONS

Product specifications subject to change without notice.
Printed in China, 3/03, Part No. 62378

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IMA-4406 Series and is the answer not in the manual?

Questions and answers

Jean Claude
February 28, 2025

How to contrôle thé loudness of thé. Unit

1 comments:
Mr. Anderson
May 14, 2025

To control the loudness of the NuTone IMA-4406 Series unit:

1. Set the SYSTEM VOLUME control on the master station to about 1/3.
2. Tune to a strong AM or FM station using the FM key and ▲▼ keys.
3. Adjust the master station’s SYSTEM VOLUME control until the desired volume is reached at the remote station needing the highest volume.
4. Each remote station (except door speakers) has its own volume control that can be adjusted individually.
5. If using the chime, adjust its volume using the potentiometer on the chime module.

This answer is automatically generated

Subscribe to Our Youtube Channel

Summary of Contents for NuTone IMA-4406 Series

  • Page 1: Operating Instructions

    IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. During this two year period, NuTone will, at its option, repair or replace, without charge, any product or part which is found to be defective under normal use and service. THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS OR TUBES.
  • Page 2: Fcc Information

    Date of Purchase Dealer Purchased from Dealer’s Address Dealer’s Phone No. Model No. IMA-4406 IMPORTANT This product has many functions and controls. Please read entire operating instructions before using this product.
  • Page 3: Table Of Contents

    Illustration of Model IMA-4406 ........
  • Page 4: Illustration Of Model Ima-4406

    5. To change the status back to the ON mode, repeat steps 1 through 4. Optional Accessories AUTO-REVERSE CASSETTE PLAYER: To complement your system, purchase an optional NuTone Auto-Reverse Cassette Player. Press the TAPE key to play the music throughout the system. ELECTRONIC DOOR CHIME or ELECTRONIC CHIME MODULE: When a NuT one Electronic Door Chime is connected to your IM-4406 system, the chime is heard at all stations in the RADIO INTERCOM and INTERCOM ONLY modes.
  • Page 5: Master Station Controls

    Deactivating the Control of Radio/CD from Remote Stations REMOTE CONTROL OF RADIO ON/OFF (Deactivating) The master station is shipped with the remote control of the Radio ON/OFF enabled. This allows the radio to be turned on and off from the remote stations. To change the status of this control mode, perform the following steps.
  • Page 6: Digital Clock

    Digital Clock Intercom Operation (continued) SETTING THE TIME ANSWERING YOUR DOOR The proper clock setting procedure is arranged in 4 segments. Each segment must be 1. Press the DOOR TALK key while you speak. completed in 5 seconds. Follow the procedure below. 2.
  • Page 7: Enabling/Disabling The Radio Timer

    Station Status Switches Digital Clock (continued) The STATION STATUS SWITCHES set the operating mode of each station in the ENABLING/DISABLING THE RADIO TIMER system. Each station may be set to one of the four following modes: RADIO 1. Press the TIMER key. The light next to the key will illuminate and the TIMER is INTERCOM, INTERCOM ONLY, OFF, or MONITOR.
  • Page 8: Cd Player Operation

    HANDLING A DISC Optional audio sources may be selected by using the following procedure. 1. Press TAPE. If an optional cassette tape player has been connected to your IMA-4406 • Be sure hands are clean when handling discs. master station, this player will be heard as an audio source. Contact your local •...
  • Page 9: Stopping The Cd Operation

    Controlling the CD Player & Radio from CD Player Operation (continued) Remote Stations (continued) STOPPING THE CD OPERATION 1. Press the STOP key on the master station to stop the CD Player. The current PLAY ADVANCING THE RADIO MEMORY CHANNELS mode (Repeat One, Repeat All, Random) and DISPLAY mode will remain.
  • Page 10: Random Play

    Remote Stations RANDOM PLAY 1. While the CD is playing, press RDM/RPT key 3 times To add convenience to your IMA-4406 CD/Radio/Intercom System, NuT one has designed to change from normal play mode to Random the capability of controlling the CD Player, AM and FM Radio operation from any room in Play mode.

Table of Contents

Save PDF