Miele PW 6241 Operating And Installation Instructions page 53
Commercial washing machine
Hide thumbs
Also See for PW 6241:
- Operating and installation instructions (72 pages) ,
- Operating instructions manual (46 pages) ,
- Fitting instructions manual (60 pages)
Table of Contents
Advertisement
Door lock fault
Call Technical Service
if restart w/o success.
Press firmly against the door handle until the door lock audibly en-
gages and press the "START" button.
Heating system fault
Program stop. Press Start.
Program runs with cold water.
Press the "START" button to continue the program without heating.
Tip: Disinfection programs will be canceled if this fault message ap-
pears.
Contact Customer Service.
Drive motor fault
Program stop. Press Start.
Motor temperature too high.
Allow the motor to cool down.
Imbalance fault
Call Technical Service
if restart w/o success.
Too large an imbalance. The imbalance switch has been triggered.
Switch the machine off and back on again and press the
"START" button.
Drain valve fault
Call Technical Service
if restart w/o success.
Check the on-site drainage system and press the "START" button.
A defective drain valve must only be repaired by Customer Service.
Dispensing system fault
Fill dispensing container ??. Press Start.
Change the dispensing canister.
Frequently asked questions
53
Advertisement
Table of Contents
