CyberData 011149 Series Operation Manual page 35

2.3.5.1 Point-to-Point Configuration
When the device is set to not register with a SIP server, it is possible to set the Office Ringer to dial
out to a single endpoint.
To set the Office Ringer to dial out to a single endpoint, complete the following steps:
1. Make sure that the
enabled. See
2. In the
address of the remote device.
3. Select Save.
Note
Operations Guide
Register with a SIP Server
Figure 2-14.
Dial Out Extension field on the
The Office Ringer can also receive Point-to-Point calls. The delayed DTMF functionality is
available in the Point-to-Point Mode. Receiving point-to-point SiP calls may not work with
all phones.
Figure 2-14. SIP Configuration Page
Device is set to NOT register with a SiP server
930386E
Installing the VoIP Indoor Office Ringer
setting on the SIP Configuration Page
Sensor Configuration Page
Parts List
is not
(see Figure 2-15), type the IP
CyberData Corporation
27