ABL Wallbox eMH1 Installation Manual page 21

Wallbox eMH1 with RJ12 interface
(eMH1 Basic and eMH1 models until mid-2021)
Remove the upper part of the housing as described in
1
section "Preparing and fixing the wallbox in place" on
page 14.
Connect the patch cable 4 to the RJ12 port located
2
on the left hand side of the interior of the wallbox.
Connect the USB extension cable 1 to one of the
3
computer's USB ports.
Use the USB to RJ45 adapter 2 to connect the patch
4
cable 4 to the USB extension cable 1.
The wallbox is now connected to the computer by cable.
Wallbox eMH1 with E2I interface
(from mid-2021)
Remove the upper part of the housing as described in
1
section "Preparing and fixing the wallbox in place" on
page 14.
Connect the patch cable 5 to one of the RJ45 ports
2
located on the left hand side of the interior of the
wallbox.
Connect the USB extension cable 1 to one of the
3
computer's USB ports.
Use the USB to RJ45 adapter 2 to connect the patch
4
cable 5 to the USB extension cable 1.
The wallbox is now connected to the computer by cable.
You can now start setting up the wallbox using the ABL Configuration Software.
ƒ Setting the charging current, activating phase unbalance detection
Read the section Configuring a single charging station > Individual settings for the charging station in the
ABL Configuration Software manual.
Configuration via software – Data cable connection with the computer |
21