Packing List Mounting hardware Mounting hardware package for 35-50mm package for 50-65mm door thickness door thickness 20mm 70mm 50mm 30mm 40mm 45mm 55mm Note: To ensure proper functioning of the device only use the 70mm mounting hardware package for your door thickness.
Door Preparation 1. Check door thickness, prepare the mounting hardware package and cylinder. Door Thickness D Spindle Length N Screw Length L Screw Length Q Screw Length E Cylinder Length (mm) (mm) (mm) (mm) (mm) (mm) 35-50 50-65 2. Check door open direction. Left inward Right inward Left outward...
Installation 1. Drill holes on the door. Installation door thickness door thickness Template 35~80mm 35~80mm center line of the handle desired handle height Indoor Outdoor Indoor Outdoor Note 1: Align the template along the vertical center line of the mortise (F) at the desired handle height, and tape it to door.
Page 6
Installation 2. Install the mortise(F). 2.2 Installing mortise (F) by 2.3 The mortise cable must inserting screws (G). through out door hole. Indoor Outdoor Indoor Outdoor Indoor Outdoor 2.1 The clutch dot must be vertically centered with mortise dot, then put this side toward outdoor.
Page 7
4.Install spindle(D). 3.Install lock cylinder(E). Indoor Outdoor Indoor Outdoor Indoor Outdoor Indoor Outdoor Note: Installing the cylinder in right direction, Note: Ensure the dot of clutch is vertically upward. put the key hole toward outdoor, then insert screw (H) to secure cylinder(E).
Page 8
5.Install outdoor unit(B) with gasket(C). 5.1 Put the gasket (C) on 5.2 Attach outdoor unit (B) to the outdoor unit(B). door by putting it through door holes. Indoor Outdoor Indoor Outdoor Note: Connect the outdoor unit (B) cable to the mortise. There are two cable on the outdoor unit, please connect appropriate cable according to the size of joint.
Page 9
6. Install mounting plate (K) with 7. Install spindle (D) on the door. gasket (C) on the door. 6.1 Put the gasket (C) on 6.2 Inserting screws (L) to 7.1 Inserting the spindle the mounting plate (K). secure the outdoor unit(B). (D) to the clutch.
8. Install indoor unit (M). 9. Install the battery . 8.1 Connect the indoor 8.2 Inserting the screws unit (M) cable to the (N) (Q) to Secure the outdoor unit (B). indoor unit (M). Indoor Outdoor Indoor Outdoor Indoor Outdoor Note: Please use Alkaline battery to make sure the lock...
Page 11
10.Mark and drill holes for striking. 21mm 15mm (Depth) 16.5mm 27.5mm...
Page 12
11.Test the lock by mechanical key(A) or registered fingerprint. Remove the cover on the key Insert the key into key hole hole with screwdriver or nails. and rotate 90°. Note: AB key system is available by contacting sales. Key A Key B AB Mechanical Key Instruction: 1.Key A is coated with brass color, which is used only for...
Page 13
Cautions 1. The default setting of the device allows ANY fingerprint to unlock. 2. Please register at least one administrator for the newly installed lock. Without administrator, no registration for any normal user is allowed. 3. The lock is equipped with mechanical keys for manually unlocking. Please keep the mechanical keys in a safe place.