Table of Contents
Advertisement
CPI Satcom & Antenna Technologies
SECTION I
GENERAL INFORMATION
1.0
INTRODUCTION
This manual describes the assembly and installation of CPI's 1.8M antenna system with Az/El mount. The
CPI 1.8M is a rugged, reliable antenna system, which will operate with high efficiency and at the same time
successfully withstand the effects of the environment. The basic 1.8M antenna consists of an offset reflector,
reflector support, feed support structure and Az/El positioner.
These instructions are listed by sections that cover all areas of assembly and installation. Additional sections
are included in the manual to provide information on antenna alignment to the satellite and maintenance.
1.1
UNPACKING AND INSPECTION
The antenna containers should be unpacked and inspected at the earliest date to ensure that all material has
been received and is in good condition.
1.2
FRIEGHT DAMAGE
Any damage to materials while in transit should be immediately directed to the freight carrier. He will
instruct you on matters regarding any freight damage claims.
1.3
MATERIAL - MISSING OR DAMAGED
Any questions regarding missing or damaged materials that is not due to the freight carrier should be directed
to CPI's Customer Service Department at:
CPI Satcom & Antenna Technologies
1700 Cable Drive NE
CONOVER NC 28613 USA
Phone 770-689-2040
www.cpii.com
4096-668
1.8M Ka-BAND Rx/Tx ANTENNA
Advertisement
Table of Contents
