Mount And Reflector Support - CPI 3180 Series Assembly Instruction Manual

CPI Satcom & Antenna Technologies
5.3 Mount And Reflector Support Structure
The mount and reflector support structure supplied with this antenna is of steel construction
and has a hot-dipped galvanized finish.
If inspection shows any signs of structural failure, the mount members that are damaged
should be repaired or replaced.
Corrosion: Any corrosion on steel members may be repaired with a cold, zinc-rich
galvanizing paint.
5.4 Feed And Feed Support
The feed support system should be inspected to insure that all hardware is secure. The
feed/radio mounting bolts should be tight.
The feed horn window should be inspected to insure that it is intact so that no moisture
can collect inside the feed horn. Replace if damaged.
4096-668
1.8M Ka-BAND Rx/Tx ANTENNA