CPI 3180 Series Assembly Instruction Manual page 10

CPI Satcom & Antenna Technologies
Installing the reflector support
1. Lift the reflector support (Item #2) and position the two mounting plates onto the AZ/El
assembly. Look for the elevation mounting bracket and ensure that it is rotated to the top of
the reflector support.
2. Install a ¾-10 x 2.00-Inch bolt with flat washer and lock washer (Items #13, 14, 15) on each
side of the reflector support.
Elevation
Bracket
3/4-inch Hardware
2 Places
(Items #13, 14, 15)
AZ/EL
Assembly
Elevation
Bracket
4096-668
1.8M Ka-BAND Rx/Tx ANTENNA
Reflector Support
(Item #2)