Table of Contents
Advertisement
CPI Satcom & Antenna Technologies
Attaching the reflector
1. Orient the reflector (Item #1) so that the feed support pocket is at the bottom.
2. Lift the reflector and position onto the reflector support.
3. Attach by inserting a 1/2-13 x 6.00-inch carriage bolt (Item #7) through each of the four holes
in the reflector from the front to the back and through the mounting holes of the reflector
support.
4. Secure with a flat washer, lock washer, and hex nut (Items #9, 10, 11) on each of the four
carriage bolts.
5. Tighten securely.
Flat Washer, Lock
Washer and Nut
4 Places
(Item #9, 10, 11)
1.8M Ka-BAND Rx/Tx ANTENNA
Reflector (Item #1)
1/2-Inch Carriage Bolt
4 Places
(Item #7)
Feed Support
Pocket at Bottom
4096-668
Advertisement
Table of Contents
