CPI 3180 Series Assembly Instruction Manual page 15

CPI Satcom & Antenna Technologies
Attaching the feed support
1. Place the feed support (Item #2) between the mounting ears of the tailpiece and into the
pocket at the bottom of the reflector.
2. Insert a 5/16-18 x 1.00-inch bolt and flat washer (Items #5, 7) through the hole in the feed
support and the hole in the top of the pocket of the reflector and secure with a flat washer,
lock washer and hex nut (Items #7, 8, 9) on the back of the reflector. Do not tighten.
With the feed support attached to the reflector, install a 5/16-18 x 5.50-inch bolt and flat
3.
washer (Item #4, 7) through the two holes in the tailpiece and feed support and secure with a
flat washer, lock washer and hex nut (Items #7, 8, 9) on each bolt. Do not tighten.
Tailpiece Support
Bracket
Feed Support
Pocket
5/16" Bolt, Flat Washer,
and Hex Nut
2 Places
(Items #7, 8, 9)
5/16-18 x 1.00" Bolt
and Flat Washer
2 Places
(Items #5, 7)
1.8M Ka-BAND Rx/Tx ANTENNA
BACK VIEW
4096-668
5/16" Bolt, Flat Washer,
and Hex Nut
2 Places
(Items #7, 8 , 9)
Reflector
5/16-18 x 5.50" Bolt and
Flat Washer
2 Places (Items #4, 7)
Feed Support
(Item #2)