CPI 3180 Series Assembly Instruction Manual page 12

CPI Satcom & Antenna Technologies
6. Attach the tailpiece support bracket (Item #5) to the reflector support by using (2) 5/16 x
5.50-inch bolts, (4) 5/16-inch flat washers, (2) 5/16-inch lock washers and (2) 5/16-inch hex
nuts (Items #16, 17, 18, 19).
7. Snug but do not tighten the two 5/16-inch bolts that attach the tailpiece support bracket to the
reflector support until after feed support installation (Section III).
Tailpiece Support
Bracket
(Item #5)
1.8M Ka-BAND Rx/Tx ANTENNA
Reflector Support
5/16-Inch Hardware
2 Places
(Items #16, 17, 18, 19)
4096-668
Reflector Support
Tailpiece Support
Bracket
(Item #5)