Table of Contents
Advertisement
CPI Satcom & Antenna Technologies
SECTION I
1.0
GENERAL INFORMATION
This manual describes the assembly and installation of CPI's 1.2 meter antenna
system. The CPI 1.2 meter is a rugged and reliable antenna which will operate in
the Ku-Band frequency with high efficiency and at the same time successfully
withstand the effects of the environment. The CPI 1.2 meter has an f/d ratio of 0.6
and an offset angle of 22.6°. This system is commonly used with a CPI ku-band
feed assembly.
These instructions are listed by sections that cover all areas of assembly and
installation. Additional sections are included in the manual to provide information
on antenna alignment to the satellite and maintenance.
1.1
UNPACKING AND INSPECTION
The system containers should be unpacked and inspected at the earliest date to
insure that all material has been received and is in good condition. A complete
packing list for each major component is supplied.
1.2
FREIGHT DAMAGE
Any damage to materials while in transit should be immediately directed to the
freight carrier. He will instruct you on matters regarding any freight damage claims.
MATERIAL – MISSING OR DAMAGED
1.3
Any questions regarding missing or damaged materials that are not due to the
freight carrier should be directed to CPI's Customer Service Department at:
INTRODUCTION
CPI Satcom & Antenna Technologies
1700 Cable Drive NE
Conover NC 28613 USA
Phone 770-689-2040
www.cpii.com
1.2M Ku-BAND SERIES 1122
4
4096-1000
Advertisement
Table of Contents
