CPI 3180 Series Assembly Instruction Manual page 16

CPI Satcom & Antenna Technologies
4. Attach a feed rod to the mounting hole in the side of the reflector with a 5/16-18 x 1.00-inch
bolt and flat washer (Items #5, 7) and secure with a flat washer, lock washer, and hex nut
(Items #7, 8, 9) on the back side of the reflector.
Reflector
5. Repeat with the remaining feed rod on the opposite side of the reflector.
6. Raise the two feed rods and attach to the feed support with a 5/16-18 x 3.25-inch bolt and flat
washer (Items #6, 7) through one feed rod, through the hole in the feed support and through
the other feed rod and secure with flat washer, lock washer and hex nut (Items #7, 8, 9).
5/16-18 x 2.75-
Inch
Hardware
5/16-18 x 1.00-Inch
Hardware Each Side
4096-668
1.8M Ka-BAND Rx/Tx ANTENNA
Feed Rod
2 Places