Advertisement
POSH
BRISTOL TORBEX SHOWER BASE
B
MODEL
A
900 x 900
900
centre rear
900 x 1200
1200
centre rear
1000 x 1000
1000
centre rear
SPECIFICATIONS
Recommended use
Material
Outlet
Waste
Base Height
CLEANING RECOMMENDATIONS
Common household cleaning products should be used according to the
manufacturers instructions. Ensure the shower base is cleaned with water
to remove any remaining cleaning product from the base.
This bathroom product should not be cleaned with abrasive materials eg.
steel wool/scourers. Do not use any corrosive or abrasive cleaning agents
containing acids or scouring agents. Bleaches can also discolour products
and therefore should not be used. Damage caused by any improper
treatment is not covered by the product warranty- refer to Warranty
Conditions on the last page.
To see the complete POSH range go to www.reece.com.au/bathrooms
Disclaimer: Products in this specification manual must by regulation be installed by licensed and registered
trade people. The manufacturer/distributor reserves the right to vary specifications or delete models from
their range without prior notification. Dimensions are nominal measurements only. Dimensions and set-outs
listed are correct at time of publication however the manufacturer/distributor takes no responsibility for
printing errors.
Tech Page Version 1
C
A
B
C
900
450
900
600
1000
500
Domestic, hotel and commercial
Torbex high strength composite
Centre Rear
Dome Cover White - Watermark approved
25mm
D
D
150
150
25mm
150
9mm
Advertisement
Table of Contents
Related Manuals for Reece POSH A
Summary of Contents for Reece POSH A
- Page 1 Warranty Conditions on the last page. To see the complete POSH range go to www.reece.com.au/bathrooms Disclaimer: Products in this specification manual must by regulation be installed by licensed and registered trade people.
- Page 2 POSH BRISTOL TORBEX SHOWER BASE INSTALLATION INSTRUCTIONS The Posh Bristol shower base has a 9mm wide tile flange. You are required to The shower base should be visually checked for check in the base against the framework, install water resistant plaster- board defects prior to installation.
- Page 3 POSH BRISTOL TORBEX SHOWER BASE FITTING INSTRUCTIONS FOR POSH BRISTOL WASTE OUTLETS Cover Silicone Ring Apply silicone in this Apply a small amount of area to the fill the gap silicone on this surface between the outlet and the shower base. Outlet Outer Tension Ring 1.
- Page 4 You have purchased a quality product from Reece Pty Ltd residential purposes, including use in non-business places ABN 84 004 097 090 (“Reece”). This product is covered by a 7 as in public buildings, schools, sports centres and in year replacement product warranty.
Need help?
Do you have a question about the POSH A and is the answer not in the manual?
Questions and answers