Reece KADO Quick Manual

It is the responsibility of the purchaser to examine and check the vanity for suitabilty and damage
Once the vanity has been installed, no claims for damage or
Please check all goods for damage and notify point of purchase of any damage/missing products.
To ensure the longevity of the unit, no part should be never be dragged, stood on and
it is recommended that the drawer runners are covered to prevent dust blocking the runners.
2. Remove the top from vanity ensuring it is in a safe spot, where it cannot be damaged/marked.
No claims for damages will be recognised after installation.
3. Having established the position of the vanity on the wall, mark and drill the holes for your
Move vanity into position and ensure it is level and square.
4. Once it is level and square, fix the vanity to the wall using the correct fitting depending on your wall
If using standard screws and star plugs, be sure to use the washers in order to spread the load.
Position fixings as shown below:
Kado Arc Timber Vanity Kado Arc Timber Vanity
PRIOR TO INSTALLATION
A licensed tradesperson must install your Rifco vanity
BEFORE installation.
incorrect goods can be made.
INSTALLATION INSTRUCTIONS
1. Remove the drawer
Open the drawer about 80%
Place drawer in a safe spot.
plumbing fixtures (ie waste outlet, hot and cold water inlets)
This may require packing behind and/or below the vanity.
(no fixing supplied).
The number of fittings used to fix cabinet will depend on the size
of unit, your installer will know the suitable amount depending on
The use of dyna bolts is recommended for masonry wall and fixing to studs
in cavity walls. Rifco does not recommend installing wall hung vanities
Plumbers, please ensure a copy of the installation instructions
is left with the end user for future reference
K A D O K A D O
the size of your cabinet.
Rifco recommends the following minimum;
Up to 900 width of vanity – 3 per row
900 to 1200 width of vanity – 4 per row
For wall hung vanities, it is essential the unit is fixed securely.
with toggle type fixing systems.
page 1 of 3
Pull upwards, not too hard,
you'll hear the click