Table of Contents
Advertisement
Section 9: Heating & Cooling
Danger of combustion, personal injury and damage to the RV!
Keep the area around the appliance free from combustible materials,
gasoline and other flammable liquids or vapors.
Switch OFF the appliance and gas supply:
• If you smell gas
• If anything appears out of the ordinary
• If you move the RV
• Before entering a gas station
• Before entering a tunnel
Danger of over-temperature and toxic exhaust gases!
Use with LP gas (propane) only. Butane or any mixtures containing more
than 10% butane must not be used.
Keep the area in front of the warm air outlets free of combustible or heat-
sensitive materials. Do not put any material into the warm air outlets.
Check that furnace vent (and air intake) terminal(s) are not obstructed in
any way during all seasons.
Danger of hot surfaces. The temperature of the exhaust gases can reach
320 °F (160 °C). Do not touch the area around the wall cowl and do not
lean any objects against the wall cowl or the RV.
Shut OFF the Combi furnace when refueling or pumping gas.
Damage to the Combi furnace caused by freezing!
The Combi furnace does not have a frost-protection function. If the heat-
ing is not used and there is a risk of freezing, all water must be drained
from the water container
Water in pipes, faucets and appliances could freeze. Considerable dam-
age may result.
Before you fill water into appliances and parts that transport water, you
must heat the installation area sufficiently so that water cannot freeze.
Selectable Modes of Operation
Heating mode
The furnace automatically selects the proper operating level based on the difference between
the desired temperature set at the control panel and the current room temperature. If there is
any water in the water container, it will be heated automatically. The water temperature will
not be regulated, but it will reach a maximum of 162 °F (72 °C).
Hot water mode (only if water container contains water)
Hot water mode is ideal if only hot water is required. The lowest burner setting suffices for
heating water. In hot water mode, the burner will switch off as soon as the water reaches
the temperature selected in the CP plus control panel. Both modes of operation can be
combined.
72
Table of Contents
Advertisement
Table of Contents
