Table of Contents
Advertisement
6.
The room must be travel locked to keep the room in place for road travel.
DO NOT MOVE THE RV UNLESS THE MOTORS ARE PLUGGED IN
TO THE CONTROLLER AND THERE IS BATTERY POWER TO THE
RV. THIS SETS THE BRAKES ON THE SLIDEOUTS TO PREVENT
THEM FROM MOVING DURING TRANSIT.
Refer to the Schwintek Slide Room Operation Guide for additional troubleshooting informa-
tion, or contact Lippert at (866) 524–7821 or at www.lci1.com.
Power Gear Below Floor Slideout System
Always disconnect battery from system prior to manually operating
system. Failure to disconnect battery can cause electricity to back feed
through the motor and cause serious damage to the system as well as void
the warranty.
Use EXTREME CAUTION when extending/retracting the room us-
ing the manual override feature. The gears can be stripped out if the
room is manually retracted/extended to its fullest extent and the operator
continues to rotate manual override. Damage can also occur to the slide
components, slide room structure or trim components. Damages due to
misuse of the manual override feature will void any and all claims to the
Limited Warranty.
Manual Override - The slideout system is equipped with a manual override that allows you
to extend or retract the room in the event of a loss of power.
If the room does not move when the switch is pressed, check the following:
Make sure the slideout system is turned on.
Battery is fully charged and connected.
Transit bars have been removed (if so equipped).
When the motor brake is disengaged the slideout room WILL NOT lock into
place and will not be sealed. When the room has been manually retracted, be
sure to install transit bars (if so equipped) and return the motor brake lever to
its normal engaged position in order to seal and lock the room into position.
If the room still does not move when the switch is pressed, follow the steps below to
manually override the slideout room:
Turn the Main Power OFF. The override will not work if it has power going to it. Do
1.
not work on the system unless the battery is disconnected.
2.
Locate the slideout controller. There are two versions of the controller.
Version 1, unplug the 6 pin wiring harness from the controller.
3.
Version 2, remove one of the motor leads, either the motor I or motor II lead from the
4.
controller.
Section 5: Slideout Systems
Table of Contents
53
Advertisement
Table of Contents
