Ip & Mac Binding; Binding Settings - TP-Link TL-WR841N User Manual

Chapter 5
• IP Range
noneffective.
• Port Range
blank or 0, the domain is noneffective.
• Protocol
• Priority
'8' stands for the lowest priority. The total Upstream/ Downstream Bandwidth is first
allocated to guarantee all the Min Rate of Bandwidth Control rules. If there is any
bandwidth left, it is first allocated to the rule with the highest priority, then to the rule
with the second highest priority, and so on.
• Egress Bandwidth
• Ingress Bandwidth
5 13
IP & MAC Binding, namely, ARP (Address Resolution Protocol) Binding, is used to bind
a network device's IP address to its MAC address. This will prevent ARP spoofing and
other ARP attacks by denying network access to a device with a matching IP address in
the ARP list, but with an unrecognized MAC address.
5 13 1
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to
3. Select
• To add IP & MAC Binding entries:
1. Click
2. Enter the MAC address and IP address.
3. Tick the
Downloaded from ManualsNet.com
- Interior PC address range. If both are blank or 0.0.0.0, the domain is
- The port range which the Interior PC access the outside PC. If all are
- Transport layer protocol, here there are ALL, TCP, UDP.
- Priority of Bandwidth Control rules. '1' stands for the highest priority while
- The max and the min upload speed which through the WAN port.
- The max and the min download speed through the WAN port.
IP & MAC Binding

Binding Settings

IP & MAC Binding > Binding
Enable for ARP Binding and click Save.
Add New.
Bind checkbox and click Save.
search engine
Configure the Router in WISP Mode
Settings.
107