Table of Contents
Advertisement
22 TROUBLESHOOTING
Faults
The engine dies during the trip
The ABS warning lamp lights
up
High oil consumption
The headlight, position light,
tail light, and license plate
lamp are not working
Combination instrument, brake
light, and horn are not func-
tional
Time is not displayed or not
correctly displayed
12-V battery discharged
The combination instrument
shows nothing in the display
142
Possible cause
Fuse 1, 2 or 3 blown
ABS fuse blown
Wheel speeds of front and rear
wheels differ greatly
Malfunction in ABS
Engine vent hose bent
Engine oil level too high
Engine oil too thin (low viscos-
ity)
Fuse 6 is blown
Fuse 5 is blown
Fuse 1 blown
Ignition was not switched off
when vehicle was parked
The 12-V battery is not being
charged by the alternator
Fuse 1, 2 or 5 blown
Action
–
Change the fuses of individual electri-
cal power consumers. (
–
Change the ABS fuses. (
–
Stop, switch off the ignition, start
again.
–
Read out the ABS fault memory using
the Husqvarna Motorcycles diagnos-
tics tool.
–
Route the vent hose without bends or
change it if necessary.
–
Check the engine oil level. (
–
Change the engine oil and the oil filter,
clean the oil screens.
(
–
Change the fuses of individual electri-
cal power consumers. (
–
Change the fuses of individual electri-
cal power consumers. (
–
Change the fuses of individual electri-
cal power consumers. (
–
Charge the 12-V battery.
–
Check the charging voltage.
–
Change the fuses of individual electri-
cal power consumers. (
–
Set time and date.
p. 122)
p. 121)
p. 133)
p. 133)
p. 122)
p. 122)
p. 122)
(
p. 119)
p. 122)
Advertisement
Table of Contents
