Remote Control - Sharp DK-CL5P Operation Manual

DK-CL5P

Remote control

■ Battery installation
This product contains a CR Coin Lithium Battery which contains
Perchlorate Material – special handling may apply. California
residents, see www.dtsc.ca.gov/hazardouswaste/perchlorate/
Note:
Before using remote control, please remove plastic shield at
battery holder.
1
Whilst pushing the locking tab towards the center of the
remote control, slide out the battery holder.
Remote
control
2
Remove the old battery from the battery holder, insert the
new battery and then slide the battery holder back into the
remote control.
Battery holder
Polarity(+)
symbol
Battery type
Locking tab
12
Back of remote
Plastic
shield
Locking tab
Battery holder
Positive (+)
Precautions for battery use:
●
Remove the battery if the unit will not be used for long periods
of time. This will prevent potential damage due to battery
leakage.
Caution:
●
Do not use rechargeable battery (nickel-cadmium battery,
etc.).
●
Danger of explosion if battery is incorrectly replaced.
●
Replace only with the same or equivalent type.
●
Batteries (battery pack or battery installed) shall not be
exposed to excessive heat such as sunshine, fire or the like.
●
control
Installing the battery incorrectly may cause the unit to
malfunction.
Notes concerning use:
●
Replace the battery if the operating distance is reduced or if
the operation becomes erratic. Purchase "CR 2025" 3 V, coin
lithium battery.
●
Periodically clean the transmitter on the remote control and
the sensor on the unit with a soft cloth.
●
Exposing the sensor on the unit to strong light may interfere
with operation. Change the lighting or the direction of the unit
if this occurs.
●
Keep the remote control away from moisture, heat, shock,
side up
and vibrations.