Remote Control; Battery Installation - Sharp DK-AP2 Operation Manual

Using with the batteries
1
Disconnect the AC/DC adaptor, and open the battery compartment.
2
Insert 4 "AA" size batteries (UM-3, R6 or similar) into the battery
compartment.
"AA" size batteries (UM-3, R6 or similar) are not included.
Battery Insertion:
Slide in batteries 1 1 1 1 and 3 3 3 3 . Then push batteries 2 2 2 2 and 4 4 4 4
towards .
Battery removal:
Push batteries 2 2 2 2 and 4 4 4 4 towards
sliding out batteries 1 1 1 1 and 3 3 3 3 .
3
Close the battery compartment.
4
The STAND-BY indicator will turn red.
Remove the batteries if the unit is not to be used for long period of time
to prevent battery leakage which may cause potential damage.
Battery replacement:
When batteries are low, sound becomes distorted and indicators will be
blinking. Reduce the volume level or replace the batteries with new ones.
Battery life:
Battery type ALKALINE (AA) (1.5 V)
Usage time Approx. 8 hrs.
Output 74 mW + 74 mW
Note:
Battery life may vary depending on the temperature, battery types and usage
conditions.
Precautions for battery use:
Installing the batteries incorrectly may cause the unit to malfunction.
Insert the batteries according to the direction indicated in the battery
compartment.
Remove the batteries if the unit is not to be used for long periods of time.
This will prevent potential damage due to battery leakage.
When using batteries, the brightness of all illumination light (indicators) is
reduced compared to using AC/DC adaptor.
Replace all old batteries with new ones at the same time.
Do not mix old and new batteries.
Batteries (battery pack or batteries installed) shall not be exposed to
excessive heat such as sunshine, fire or the like.
and remove the batteries before
Caution:
Do not use rechargeable batteries (nickeI-cadmium battery, etc.).
Changing power source:
Turn off the unit before changing the power source. If the 6V DC power
supply is directly plugged in during power on, the unit may automatically
enter to stand-by mode. Press the ON/STAND-BY button again to turn on the
unit.

Remote control

Battery installation

This product contains a CR Coin Lithium Battery which contains Perchlorate
Material – special handling may apply. California residents, see
www.dtsc.ca.gov/hazardouswaste/perchlorate/
1 Whilst pushing the locking tab towards the centre of the remote
control, slide out the battery holder.
2 Remove the old battery from the battery holder, insert the new
battery and then slide the battery holder back into the remote
control.
Battery holder
Polarity (+) symbol
Battery type
Locking tab
Precautions for battery use:
Remove the battery if the unit will not be used for long periods of time.
This will prevent potential damage due to battery leakage.
Caution:
Do not use rechargeable battery (nickel-cadmium battery, etc.).
Replace only with the same or equivalent type.
Installing the battery incorrectly may cause the unit to malfunction.
Danger of explosion if battery is incorrectly replaced.
Batteries (battery pack or batteries installed) shall not be exposed to
excessive heat such as sunshine, fire or the like.
Back of remote control
Locking tab
Positive (+)
side up
DK-AP2
DK-AP2(BK)
ENGLISH
E-6