Pars ABL GIANT 3.0 Manual page 41

CENTRE BRUSH
REPLACEMENT OF CENTRE BRUSH
Brushes should be replaced before ever they wear out completely.
Once the length of brush has shortened to below its half original length the sweep becomes
inefficient, ineffective and therefore costly. From then on dirt and debris will be spread over
the road surface rather than swept and deposited properly to elevator
Sweeper is equipped with one complete roller brush with core of plastic, brush material can
be in poly, steel or mixed poly/steel
- Unscrew the four bolts from bearing (A)
- Remove the bearing from the shaft (B)
- Unscrew bolt (C) from lock brush (D)
- Remove centre brush (E) from shaft (B)
- Replace with new Centre brush
41