Pars ABL GIANT 3.0 Manual page 29

LUBRICATION AND MAINTENANCE INTERVAL SCHEDULE
DIESEL ENGINE MAINTENANCE EVERY 500 HOURS
Replace of primary Fuel filter with water separator with manual priming pump
- Place a suitable container under the water separator to catch any fuel that might
spill. Clean-up any spilled fuel. Clean the outside body of the filter assembly
- Install a suitable tube onto drain (2) open the drain valve (1) rotate the drain valve
fully counter clockwise. Two full turns are required
- Allow the fuel to drain into the container
- Remove the tube from the drain (2)
- Remove the wiring harness from connection (3)
- Rotate filter bowl (5) counter clockwise and remove the filter bowl from assembly
- Remove the filter element (4) clean the filter bowl
- After repositioning the self-venting drain up, locate the thread in new filter element
(6) onto the thread (7) spin on the filter element and tighten the drain valve (2)
securely
- Lubricate the lip (X) with clean engine oil. Do NOT fill the bowl with fuel before the
assembly is installed
- Align the filter bowl (5) to the assemble. Rotate the filter bowl (5) clockwise by hand.
Rotate the filter bowl (5) until there is no visible gap between the element and the
filter bowl and the assembly
- Remove the container and dispose of the fuel in a safe place
- Install the wiring harness to connection (3)
- The secondary filter element (If equipped) must be replaced at the same time
DO NOT USE A TOOL TO INSTALL THE FILTER ASSEMBLY
29