Replacement Of Wear Parts - Pars ABL GIANT 3.0 Manual

SIDE BRUSH
REPLACEMENT OF SIDE BRUSH
Brushes should be replaced before ever they wear out completely.
Once the length of brush has shortened to below its half original length the sweep becomes
inefficient, ineffective and therefore costly. From then on dirt and debris will be spread over
the road surface rather than swept and deposited properly to elevator
Sweeper is equipped with two brushes with wooden frame, consisting of three rows of
brush. Brush material can be in Poly, Steel or mixed Steel/poly
- Unscrew the four nuts from the carrier (A)
- Remove the brush (B)
- Replace with new brush
- Tighten the nuts again into the carrier (A)
40