Related Manuals for Motorline professional MC70 EVO
Summary of Contents for Motorline professional MC70 EVO
- Page 1 MC70 EVO MC70 EVO USER/INSTALLER MANUAL V1.2 REV. 03/2022 Compatible hardware versions: 27042021 | 24092021...
- Page 2 CONNECTION TO A SINGLE WALL SWITCH European Parliament and of the Council, of 8 June 2011, on CONNECTION OF SEVERAL MC70 EVO CONTROL BOARDS - MASTER FUNCTION the restriction of the use of certain hazardous substances in electrical and electronic equipment and with Delegated 03.
-
Page 3: General Warnings
01. SAFETY INSTRUCTIONS GENERAL WARNINGS • Children shouldn’t play with the product or opening devices to avoid the motorized door or gate from being triggered involuntarily. • This manual contains very important safety and usage information. very important. Read all instructions carefully before beginning the WARNINGS FOR TECHNICIANS installation/usage procedures and keep this manual in a safe place that it can be consulted whenever necessary. - Page 4 01. SAFETY INSTRUCTIONS RESPONSABILITY • Attach the permanent label for the manual release as close as possible to the release mechanism. • Supplier disclaims any liability if: • Disconnect means, such as a switch or circuit breaker on the electrical •...
- Page 5 02. CONNECTIONS SCHEME 02. CONNECTIONS SCHEME CONNECTION TO A DOUBLE WALL SWITCH CONNECTION TO A SINGLE WALL SWITCH MOTOR 230V PULL MASTER MOTOR 230V PULL MASTER AB FCH 1 2 3 4 5 6 7 8 9 10 1 2 3 4 5 6 7 8 9 10 230V 230V Motor...
- Page 6 CONNECTION OF SEVERAL MC70 EVO CONTROL BOARDS - MASTER FUNCTION The MC70 EVO control board MASTER function allows to connect and control several MC70 EVO control boards in the same wall switch (MASTER switch). In this way, whenever a Master switch button is pressed, all the interconnected control boards send a impulse to the motors to start the maneuver at the same time.
-
Page 7: Technical Characteristics
Example: Open - Stop - Close - Stop -Open (...) MC70 EVO control boards in the same push button The programmed remote control will work with the buttons: OPEN | CLOSE | STOP. (MASTER switch). - Page 8 04. PROGRAMMING 04. PROGRAMMING REMOTE CONTROLS PROGRAMMING PROGRAMMING REMOTE CONTROLS THROUGH A ALREADY PROGRAMMED ONE This control board only allows programming MOTORLINE rolling code remote controls by a maximum of Program a new remote control (1 button) through another already programmed: 120 remote controls.
- Page 9 04. PROGRAMMING 04. PROGRAMMING PROGRAMMING OF REMOTE CONTROLS THROUGH SWITCH CHANGE THE MOTOR DIRECTION 01 • Press and hold the CLOSE button of an already programmed remote control. Program a new remote control (3 buttons) using a double switch: 02 • Connect the control board to a 230V power supply. 01 •...
Need help?
Do you have a question about the MC70 EVO and is the answer not in the manual?
Questions and answers