European Parliament and of the Council, of 8 June 2011, on 03. CONTROL BOARD the restriction of the use of certain hazardous substances in electrical and electronic equipment and with Delegated MCONNECT SHUTTER Directive (EU) 2015/863 from Commission. GRAPHIC DESCRIPTION TECHNICAL SPECIFICATIONS (Applicable in countries with recycling systems).
01. SAFETY INSTRUCTIONS GENERAL WARNINGS • Children shouldn’t play with the product or opening devices to avoid the motorized door or gate from being triggered involuntarily. • This manual contains very important safety and usage information. very important. Read all instructions carefully before beginning the WARNINGS FOR TECHNICIANS installation/usage procedures and keep this manual in a safe place that it can be consulted whenever necessary.
Page 4
01. SAFETY INSTRUCTIONS RESPONSABILITY 16 September 2009. • Attach the permanent label for the manual release as close as possible • Supplier disclaims any liability if: to the release mechanism. • Product failure or deformation result from improper installation • Disconnect means, such as a switch or circuit breaker on the electrical use or maintenance! panel, must be provided on the product’s fixed power supply leads in •...
CONNECTION TO WALL SWITCH OF 2 KEYS MCONNECT SHUTTER The MCONNECT SHUTTER was developed to control roller shutters by distance or push button, using the MCONNECT app and a module previously connected to the application. Its small size allows the installation inside a junction boxes, behind electrical switches (push buttons).
3 • Connect module wires to the installation • Construction material wires (see page 4A). 4 • Insert the MCONNECT SHUTTER module inside • The existence of a Wi-Fi network is required in the space where the device will be working; the junction box.
05. CONFIGURATION 05. CONFIGURATION OPERATING SETTINGS ADD MODULE IN IN THE APP SWITCH MODE 1 • Open MCONNECT app. 2 • Log in. • PULSE 3 • On the home page press the "+" button at the top right. The shutter changes state when the pulse switch is 4 •...
06. TROUBLESHOOTING INSTRUCTIONS FOR FINAL CONSUMERS/TECHNICIANS PROBLEM SOLUTION The LED reader does not light up Check that the power is connected correctly. The module is not in pairing mode Press the Reset button located on the back of the modu- (LED flashing purple) and I haven't le, until it switches to pairing mode.
Need help?
Do you have a question about the MCONNECT SHUTTER and is the answer not in the manual?
Questions and answers