H3C S12500X-AF Series Installation Manual page 55

Figure3-8 Installing an LPU with common ejector levers (S12516X-AF switch)
(1) Push the LPU slowly along the guide rails into the slot
(3) Push the LPU by the middle part on the front panel
(5) Fasten the captive screws on the LPU
Installing an LPU with foldable ejector levers
1. Orient the LPU with the lettering on it upward.
2. As shown by callout 1 in Figure3-9, holding the LPU by the front panel with one hand and
supporting its bottom with the other, slide the LPU gently into the slot along the slide rails.
Keep the LPU parallel to the slot to avoid damaging other components in the chassis.
3. When most part of the LPU is inserted into the slot, simultaneously pivot the ejector levers
towards each other until they stop, as shown by callout 2 in Figure3-9.
4. As shown by callout 3 in Figure3-9, rotate the ejector levers away from the front panel until they
stop.
5. As shown by callout 4 in Figure3-9, push the LPU by its middle part on the front panel until you
cannot move it.
5
4
1
2
3
4
(2) Pull the ejector levers outward
(4) Pull the ejector levers inward
3-12
2