Remote Controller - Sanyo FXCD-1350 Operating Instructions Manual

REMOTE CONTROLLER

REMOTE CONTROLLER OPERATION
Not used
BAND button
Change reception band
SCN button
• Radio mode:
Scan a preset station
• CD/CD-CH mode:
Play introduction to
current DISC
• TAPE mode:
Play introduction
TUNE Button
.
• Radio mode:
Short press:
Station selected manually
(to low frequency station)
Long press:
Station selected automatically
(to low frequency station)
• CD mode:
Short press:
Rewind to a previous track
Long press: Fast rewind
• TAPE mode:
Fast rewind
SHF Button
• CD mode:
SHUFFLE current DISC
• CD-CH mode:
SHUFFLE current DISC
SOUND Button
SOUND EFFECT
switching mode
JAZZ FLAT ROCK
PRESET (-) Button
• Radio mode:
Select a registered station
• CD-CH mode:
DISC change
CAUTION
• For the purpose of safe driving, a passenger other than a driver should operate a remote
controller while the vehicle is being driven, or the operation should be done after parking the
vehicle in a safe area.
PRESET (+) Button
• Radio mode:
Select a registered station
• CD-CH mode:
DISC change
TAPE Button
Switch to TAPE mode
Switch DIRECTION
PWR Button
Power ON/OFF
VOL(+/-) Button
Adjust volume
+: Volume up
-: Volume down
DISP Button
Changeover of
clock display
-5-
CD Button
Change to CD mode
Switch between CD and
CD-CH when CD CHANGER
is connected
ATP Button
• Radio mode:
Select a station
received by ATP
• TAPE mode:
AMSS switching
Select title using
TUNE ( ) button
TUNE Button
• Radio mode:
Short press:
Station selected manually
(to higher frequency )
Long press:
Station selected automatically
(to higher frequency )
• CD mode:
Short press:
Skip to the next track
Long press: Fast-forward
• TAPE mode:
Tape fast-forward
RPT Button
• CD mode:
REPEAT current title
• CD-CH mode:
REPEAT current title
• TAPE mode:
REPEAT current title
AUDIO Button
Sound quality modulation
switching mode
BASS TREBLE
BALANCE FADER
Adjust using VOL button (+/-)