Install The Water Filter - Samsung RM255BABB Training Manual

DISASSEMBLY AND REASSEMBLY
Connect the water line to the refrigerator.
1) Slip the compression nut and plastic ferrule
through the plastic tube.
2) After inserting the sleeve, tighten the compression
nut onto 1/4" compressionfitting(union).
Do not overtighten the compression
nut.
NOTE
3) Slip the compression ferrule and nut on
copper (or plastic) tubing as shown.
Tighten the compression nut onto the
compression fitting(union).
4) Turn water on and check for any leakage.
Water line must be connected to drinkable water only.
NOTE
Cut off 1/4 inch squarely to prevent leaks when reconnected.

Install the water filter.

1) Open the cartridge cover as shown by pulling and pushing up at the front,
The water filter cartridge is located at the upper right corner of the refrigerator compartment.
NOTE
When the display in the control panel "filter change", it is mecessory to be changed the filter cartridge.
2) Remove the water filter from the box then position the arrow of the cartridge in line with the cartridge cover.
Under the high water pressure, water drops may happen.
NOTE
If you put the small tray beneath the hole of filter cover, it will be helpul to clean the shelf.
3) Insert the filter as shown and Push until you hear the clicking sound.
Be sure to align the hook of the filter catridge and housing.
NOTE
4) Close the filter cartridge cover.
After changing filter cartridge, drain the first six glassful of water off to remove the trapped air.
NOTE
Do not repeat pushing and pulling, water pressure and trap will make a spurt of water.
46 46
Compression Nut
Ferrule
Sleeve
Compression fitting
Ferrule
Compression Nut