Install The Water Filter - Samsung REFRIGERATOR Owner's Manual And Installation

INSTALLATION OF THE WATER DISPENSER LINE

Install the water filter.

The water filter is located in the extra space behind the Deli Bin.
NOTE
1) Remove the fixed cap (A) as shown. the fixed cap separates from the Water Filter
Compartment by rotating it as shown.
Remove the water filter from the box and put a month
indicator sticker on the filter as shown.
Keep the cap(A) in a safe place for recapping, when
NOTE
you don't need to use the filter.
2) If the water filter was installed in March, put on the "SEP" sticker.
3) Remove the Red protective cap from the filter, then position and insert the filter as shown.
4) Slowly turn the water filter as shown below to align the indication mark on the cover, lock-
ing the filter in position. Do not overtighten.
STICKER
(MONTH INDICATION)
Please check that the indication line aligns with the lock position.
NOTE
Remove any residual matter inside the water supply line after installing the filter.
1) Turn on the main water supply & shut-off valve of the water supply
line.
2) Run water through the dispenser until the water runs clear (6~7
minutes). This will clean the water supply system and clear air from
the lines.
3) Additional flushing may be required in some households.
4) Open the refrigerator door and check if water leaks around the
water filter.
A newly-installed water filter cartridge may cause
NOTE
water to briefly spurt from the dispenser.
SEPARATION
OF RED CAP
28
(A)
COVER FILTER
ALIGN THE INDICATION MARK
WITH LOCK POSITION.
ICE
WATER