Husqvarna DC 6000 Operator's Manual page 86

Maintenance
Replace the filter.
To clean the dust extractor
It is important to clean the dust extractor to prevent
circulation of dangerous dust. Always clean the dust
extractor before it is moved from the work area.
WARNING:
its OFF position and disconnect the cord
from the wall outlet before you clean or do
maintenance to the product.
• All equipment once used must be regarded as
contaminated and be treated thereafter.
• All parts that are contaminated after service work
must be disposed in a correct procedure in plastic
bags. Refer to local regulations.
• Use correct personal equipment when you clean the
Personal protective equipment on
product. Refer to
page 80 .
• Clean the external surface with a moist cloth.
• Clean the filters and the dust extractor in applicable
area.
• Vacuum the pre-filter from the inside. Always use
dust extractors with Hepa filter and a soft brush to
not damage the filter.
• Do not use water on electrical components.
• Do not clean the dust extractor with high pressure
(air or water).
• Do not put tools on the surface of the filter, it can
cause damage to the filter.
• Do not make a hole in the Hepa filter, it can cause a
health risk.
86
Daily
Turn the motor switch to
Weekly Monthly
To do a check of the cyclone and
container
1. Turn the ON/OFF switch to the OFF position.
2. Wait for 30 seconds.
3. Lower the product to transport position and install
the frame pin.
4. Open the 3 snap locks on the cyclone container.
5. Lift the lid on the cyclone container.
6 months or
1000h
X
1883 - 001 - 01.06.2022