Parameter Function - MIMAKI CJV150 Series Service Documents

Service Documents > Technical Information > Basic Information > Parameter Function
Model CJV150/300 Issued 2014.09.15 Revised

4.1.4 Parameter Function

 Outline
With the PARAMETER function, you can check and set parameters on the machine. (Available in service mode)
Be sure to upload parameters before changing them.
There is a possibility that input errors may make recovery impossible.
 Parameter function items
No. Item
1 SYSTEM PARAMETER
2 MAINTENANCE PARAMETER A group of parameters for firmware debugging and assessment in the
3 SERVO PARAMETER
4 FEED PARAMETER
5 HEAD PARAMETER
6 OPE PARAMETER
7 INK PARAMETER1
8 INK PARAMETER2
9 DEBUG PARAMETER
10 SCAN PARAMETER
11 NOZZLE RECOVERY PARAM-
ETER
*1.Do not change the disapprove parameter without instructions from developer.
© 2014 MIMAKI ENGINEERING CO.,LTD.
F/W ver
Description
A group of parameters as a storage of adjusted values for each machine
(printing)
development stage
A group of parameters for XY motor control.
A group of parameters for feed control.
A group of parameters to save the dot position correction and the head
voltage (correction value)
A group of parameters for operation control.
A group of parameters as a storage of the operation status of the
machine
Parameters for control of function related to ink system.
Parameters for evaluation of debug in development
A group of parameters for scan control.
Parameters to save nozzle numbers registered at nozzle recovery
1.10 Remark
Rev.
1.0
1
Change
Partially
permitted 2
Partially
permitted
Disap-
*1
prove
Disap-
3
prove
Permitted
Disap-
prove
4
Partially
permitted
Disap-
prove
Disap-
prove
Disap-
prove
Disap-
prove
4.1.4 R.1.0 P.1