Checking Chain Lubrication; Adjusting The Telescoping Shaft - Stihl HT 105 Instruction Manual

English
1
left: Base of fuel cap is tilted –
interior marking (1) is aligned
with the exterior marking
right: Bottom of the fuel cap in cor-
rect position – inner mark is
under the grip. It does not
align with the exterior
marking
Fit fuel cap and twist it
N
counterclockwise until it engages in
the seat of the filling port
Continue to twist the fuel cap
N
counterclockwise (approx. 1/4 turn)
– this will twist the base of the cap
into the correct position
Twist the fuel cap clockwise and
N
close it – see section "Closing"
18

Checking Chain Lubrication

The saw chain must always throw off a
small amount of oil.
NOTICE
Never operate without chain lubrication.
If the chain runs dry, the whole cutting
attachment will be irretrievably damaged
within a very short time. Always check
chain lubrication and the oil level in the
tank before starting work.
Every new chain has to be broken in for
about 2 to 3 minutes.
After breaking in the chain, check chain
tension and adjust if necessary – see
"Checking Chain Tension".
Adjusting the Telescoping
Shaft
WARNING
Always shut off the engine and fit the
chain scabbard!
Loosen the clamp nut half a turn
N
counterclockwise
Adjust the shaft to the required
N
length
Tighten the nut clockwise
N
HT 105, HT 134, HT 135