Using The Unit - Stihl HT 105 Instruction Manual

English
STIHL recommends the use of genuine
STIHL replacement parts. They are
specifically designed to match your
model and meet your performance
requirements.
To reduce the risk of injury from
unintentional engine startup, always
shut off the engine and disconnect the
spark plug boot before performing any
repairs, maintenance or cleaning work. –
Exception: Carburetor and idle speed
adjustments.
Do not turn the engine over on the
starter with the spark plug boot or spark
plug removed since there is otherwise a
risk of fire from uncontained sparking.
To reduce the risk of fire, do not service
or store your machine near open flames.
Check the fuel filler cap for leaks at
regular intervals.
Use only a spark plug of the type
approved by STIHL and make sure it is
in good condition – see "Specifications".
Inspect the ignition lead (insulation in
good condition, secure connection).
Check the condition of the muffler.
To reduce the risk of fire, do not operate
your machine if the muffler is damaged
or missing – there is also a risk of
hearing damage.
Do not touch a hot muffler since burn
injury will result.
Shut off the engine
before checking chain tension.
–
before retensioning the chain.
–
before replacing the chain.
–
before rectifying problems.
–
8
Observe sharpening instructions – keep
the chain and guide bar in good
condition at all times for safe and correct
handling of the machine. The chain must
be properly sharpened, tensioned and
well lubricated.
Always change the chain, guide bar and
sprocket in good time.
Store fuel and chain lubricant in properly
labeled, safety-type canisters only.
When handling gasoline, avoid direct
contact with the skin and avoid inhaling
fuel vapor – health risk.
Maintenance, replacement, or repair of
the emission control devices and
systems may be performed by any
nonroad engine repair establishment or
individual. However, if you make a
warranty claim for a component which
has not been serviced or maintained
properly, STIHL may deny coverage.
For any maintenance please refer to the
maintenance chart and to the warranty
statement near the end of the instruction
manual.

Using the Unit

Preparation
Wear suitable protective clothing,
N
observe safety precautions.
Adjust telescoping shaft to the
N
required length (HT 105, HT 135
only)
Starting the engine
N
Fitting the harness
N
Cutting sequence
To allow branches to free fall, always cut
the lower branches first. Prune heavy
branches (large diameter) in several
controllable pieces.
WARNING
Never stand directly underneath the
branch you are cutting – be wary of
falling branches. – Note that a branch
may spring back at you after it hits the
ground – risk of injury.
Disposal
Do not throw cuttings into the garbage
can – they can be composted.
Working techniques
Hold the control handle with your right
hand, and the shaft with your left hand.
Your left arm should be extended to the
most comfortable position.
HT 105, HT 134, HT 135