Checking Chain Lubrication; Adjusting The Telescoping Shaft - Stihl HT 131 Instruction Manual

English
1
Left: Bottom of cap is twisted –
inner mark (1) in line with
outer mark.
Right: Bottom of cap in correct posi-
tion – inner mark is under the
grip. It is not in line with the
outer mark.
Place the cap on the opening and
N
rotate it counterclockwise until it
engages the filler neck.
Continue rotating the cap
N
counterclockwise (about a quarter
turn) – this causes the bottom of the
cap to be turned to the correct
position.
Turn the cap clockwise and lock it in
N
position – see section on "Closing".
18

Checking Chain Lubrication

The saw chain must always throw off a
small amount of oil.
NOTICE
Never operate your saw without chain
lubrication. If the chain runs dry, the
whole cutting attachment will be
irretrievably damaged within a very short
time. Always check chain lubrication and
the oil level in the tank before starting
work.
Every new chain has to be broken in for
about 2 to 3 minutes.
After breaking in the chain, check chain
tension and adjust if necessary – see
"Checking Chain Tension".
Adjusting the Telescoping
Shaft
HT 101, HT 131 only
WARNING
Always shut off the engine and fit the
chain guard
Loosen the screw.
N
Adjust shaft to the required length.
N
Tighten down the screw firmly.
N
HT 100, HT 101, HT 130, HT 131