Table of Contents
Advertisement
Problem solving guide
General problems with the tumble dryer
Problem
You can hear buzzing or
humming operating
noises.
A programme cannot be
started.
When the DryFresh,
PowerFresh or
DryCare 40 Extras are
selected, the drying
level "jumps back" to a
different one.
The display is dark and
the Start/Stop sensor is
flashing slowly.
The dryer is switched
off at the end of the
programme.
The display is in a
different language.
72
Possible cause and remedy
The compressor (heat pump) is operating. Or you
have selected a programme which sprays
condensed water into the drum.
No action is required. These noises are quite
normal and can be heard when the compressor
or the condensed water pump is operating.
There is no fault.
There is no obvious cause.
Connect the tumble dryer to the mains electricity
supply
Turn on the tumble dryer.
Close the door.
Check whether the mains fuse has tripped.
Has there been a power cut? When power is
restored, any previously running programme will
restart automatically.
The drying level you selected previously cannot be
combined with the Extra. The closest possible
drying level is selected automatically.
The display has switched off automatically to save
energy (Standby mode).
The drum will rotate from time to time when the dryer
is in the Anti-crease phase.
Touch any sensor. This switches Standby off.
The tumble dryer switches off automatically. This is
not a fault, but a normal function.
A different language has been selected in "Settings -
Language ".
Set the language you want. The flag symbol serves
as a guide.
Advertisement
Table of Contents
