Table of Contents
Advertisement
Heat pump technology and refrigerant:
The heat pump in this tumble dryer uses a gaseous refrigerant. The
refrigerant, which is brought to a higher temperature and liquefied by
condensing, is transferred in a closed circuit through the heat
exchanger unit where heat exchange takes place with the circulating
drying air.
Damage to the tumble dryer by switching it on too soon.
This can damage the heat pump.
After setting up the tumble dryer, wait for at least one hour before
switching it on.
- The humming noises caused by the heat pump during the drying
process are normal. They do not impair the efficient functioning of
the dryer.
- The refrigerant is not flammable or explosive.
Please observe the instructions in "Installation" and "Technical
data".
The plug and socket must be accessible at all times in order to be
able to disconnect the tumble dryer from the power supply.
Do not block the gap between the bottom of the tumble dryer and
the floor with plinth facings, deep pile carpet etc. This would hinder a
sufficient flow of air to the tumble dryer.
Make sure the dryer door can be opened without hindrance after
installation.
In areas which may be subject to infestation by cockroaches or
other vermin, pay particular attention to keeping the appliance and
its surroundings in a clean condition at all times. Any damage which
may be caused by cockroaches or other vermin will not be covered
by the warranty.
Warning and Safety instructions
13
Advertisement
Table of Contents
