Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Spraying Systems Co GunJet 30A
Summary of Contents for Spraying Systems Co GunJet 30A
- Page 1 30A and 30AW GunJet Spray Gun ® USER GUIDE MI-30A & 30AW spray.com...
-
Page 2: Table Of Contents
Contents CONTENTS ......................2 INTRODUCTION ....................3 WARNINGS & PRECAUTIONS ................4 INSTALLATION ...................... 6 MAINTENANCE ..................... 7... -
Page 3: Introduction
30AW GunJet spray guns are identical and require the same installation and operating procedures. The Model 30A and 30AW GunJet spray guns will accommodate standard Spraying Systems Co. accessories for both the inlet and the outlet connections with the accessories’ pressure and temperature limitations. -
Page 4: Warnings & Precautions
3. DO NOT alter equipment in any manner; if repairs are necessary, use only genuine factory repair parts supplied by Spraying Systems Co. 4. DO NOT exceed maximum operating pressure of the lowest rated accessory item within the spray system even though some of the accessories have a higher maximum pressure rating. - Page 5 7. DO NOT use a GunJet with a faulty or damaged Trigger Lock. 8. DO NOT operate a spray gun if there are any leaks from the packings, fittings, hoses, etc. Fluids that are under high pressure can penetrate skin, cloth, etc., and cause serious injury. 9.
-
Page 6: Installation
INSTALLATION 1. Before installing GunJet® to hose, select WashJet® tip or, if desired, an appropriate extension and WashJet nozzle for your application. Install on gun with nozzle positioned for your particular spraying needs and tighten. 2. Make sure all power is turned off to the pump. Attach GunJet to high-pressure hose with rating to meet or exceed the maximum operating pressure to be used. -
Page 7: Maintenance
With proper care, your Model 30 series GunJet will give you reliable service. To maintain this performance, parts should be inspected regularly and replaced when necessary with genuine Spraying Systems Co. parts. DISASSEMBLY PROCEDURE (See Figure 1 and parts list PL 30A & 30W) If it becomes necessary to disassemble this unit, follow these steps: 1. - Page 8 FIGURE 1 FIGURE 1A ASSEMBLY PROCEDURE (See Figure 1 and parts list PL 30A & 30W) 1. Install Main Spring (7) over Main Stem (6). 2. Install Washer (8) onto Main Stem (6). 3. If Cup Packing (9) and Back-up Ring (10) were not previously removed from Packing Screw (12) apply a drop of light oil on Cup Packing and carefully thread Packing Screw (12) over threads of Main Stem (6).
- Page 9 9. Thread flat side of hex Stem Nut (13) onto threaded end of Main Stem (6) until approximately 3/16” of threaded stem projects from recessed surface of Stem Nut (13). 10. Install #6 Burr (washer) (15), Spring (14), and end of Main Stem (6) which has hex Stem Nut (13) onto Trigger Guide (19).
- Page 10 Parts List...
- Page 12 North Avenue and Schmale Road, P.O. Box 7900, Wheaton, IL 60187-7901 Tel: 1.800.95.SPRAY Intl. Tel: 1.630.665.5000 Fax: 1.888.95.SPRAY Intl. Fax: 1.630.260.0842 www.spray.com MI 30A/30AW © Spraying Systems Co. 2019...
Need help?
Do you have a question about the GunJet 30A and is the answer not in the manual?
Questions and answers