Mounting; Wall Mount - Welch Allyn 48700 Operating Instructions Manual

MOUNTING

Use one of the following three mounting options in order to
ensure proper operation of the light box.

Wall Mount

Choose appropriate mounting location. The length of the light pipe
is 4 feet totally extended (fiberoptic light cable is 7 .5 feet). When
choosing a mounting location, keep these dimensions in mind in
addition to accounting for the actual application the light will be
used for and what portion of the examination table will need to be
accessed.
1. Using the mounting plate as a template, mark drilling holes as
needed (depending on your wall type).
• Dry Wall, Paneling, Plywood or Plaster
(1/8 inch (.3 cm) to 5/8 inch (1.6 cm)
thick) - drill four (4) 3/8 inch (1cm) holes,
insert hollow metal wall anchor
assembly.
• Concrete Block - drill four (4) 3/16 inch
(5 cm) holes, insert plastic anchors.
Use #8 x 1/2 inch screws to secure.
• Metal Panel or Plywood walls greater
than 5/8 inch (1.60 cm) thick - drill four
(4) 1/8 inch (.3 cm) holes. Use #8 x 1
inch screws to secure.
2. Once holes are drilled, install the mounting plate with the
appropriate screws. Completely tighten the screw so there is
no gap between the screw head and the mounting plate.
7