Related Manuals for JWA WANDSWORTH 68963
Summary of Contents for JWA WANDSWORTH 68963
- Page 1 ASSEMBLY INSTRUCTION WANDSWORTH Dining Chair ITEM CODE: 68963 Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia. For any assistance with assembly or for missing parts please refer to your receipt...
- Page 2 PRE-ASSEMBLY PREPARATION Before you start: 1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product 2. Take care when lifting. Product should be assembled as near as possible to the point of 3. Ensure that you have all required contents for complete assembly 4.
- Page 4 STEP 1: • Prepare a protected surface, either with a blanket or cardboard. • Prepare 8x bolt A sets. Thread bolt(A) through spring washer(C), then washer(D). • Connect the long apron(2) to the long end of the left leg(4) and right leg(5), use the dowels(E), in the middle hole at each corner.
- Page 5 STEP 2: • Prepare 2 bolt B sets, by threading bolt(B) through spring washer(C), then washer(D). • Attached the base to the seat(1) as shown below. • Secure on the connecting points on the left and right legs with bolt set B. •...
- Page 6 STEP 4: • Stand the chair the right way up on a level surface. Push down on the chair until it levels out. Do not lean beyond your own balance. • Once level, flip the chair back over again (upside down). Now go around in a clockwise direction and fully fasten all the bolts.
- Page 7 PRODUCT CARE: REGULAR CARE: • Protect from direct sunlight • Vacuum regularly using low suction • Rotate reversible cushions regularly • Avoid exposure to new clothing, cushions or throws as this may lead to dye transfer and permanent staining CLEANING: •...
Need help?
Do you have a question about the WANDSWORTH 68963 and is the answer not in the manual?
Questions and answers