Primary-Secondary Configuration | Wifly Setup - ADJ WIFLY EXR HEX5 IP User Manual

Hide thumbs Also See for WIFLY EXR HEX5 IP:

Table of Contents

This function will allows units to be linked together to run in a Primary-Secondary setup, with one

unit will act as the controlling unit and the others will react to the controlling unit's programs. Any

unit can act as a Primary or as a Secondary, but only one unit can be programmed to act as the

"Primary."

Connections and Settings:

1. Daisy chain your units via the XLR connector on the rear panels of the units. Use standard XLR

data cables to link your units together. Remember that the male XLR connector is the input and

the female XLR connector is the output. The first unit in the chain (primary) will use the female

XLR connector only, and the last unit in the chain will use the male XLR connector only.

2. Set the "Primary" unit to your desired mode of operation.

3. On each of the "Secondary" units, press the MODE button until "Secondry Mode" is displayed.

The unit is now set as the "Secondary" unit. Each secondary unit must be set to the same set-

ting.

4. Connect the first "Secondary" unit to the "Primary". The "Secondary" unit should now start to fol-

low the "Primary".

With this feature, the unit can be controlled wirelessly with DMX. Your DMX controller must be con-

nected to a ADJ WiFly Transceiver to use this function. Maximum range is up to 2500 feet/760

meters (open line of sight).

1. Follow the instructions shown in the Operating Instructions section of this manual to set the

WiFly address and to activate WiFly. The address must match the address set on the WiFly

Transceiver.

2. Select your desired DMX Channel mode and set your DMX address. Refer to the Operating

Instructions section of this manual for detailed instructions.

3. Apply power to the ADJ WiFly Transceiver. Please note that the fixture must be set up first before

you apply power to WiFly Transceiver.

4. If everything is set up properly and the fixture is receiving a wireless signal, you should now be

able to control it with a DMX controller.

PRIMARY-SECONDARY CONFIGURATION

WIFLY SETUP

Table of Contents

Need help?

Do you have a question about the WIFLY EXR HEX5 IP and is the answer not in the manual?

Wif290