Advertisement
How to mount
1.
Flip the projector upside down.
2.
Release four screws from the bottom plate, as indicated by the following picture (reference 1,
Use a 3 mm Allen wrench to loosen the screws.
Image 2–5 Screws from the bottom plate to be removed
3.
Mount the foam and filter on the bottom plate as illustrated in the following picture.
Image 2–6 Mounting the botto filter
4.
Drive the previously removed screws back into the bottom plate of the projector. Use a 3 mm Allen wrench
to tighten the screws.
2.4 Maintenance of the filters
Preventive maintenance period
Similar to the other filters of the UDX, it is advised to inspect the filters once per month. Do this by doing a
quick check on the outside and comparing it to filters that are easier to access (top filter and side filter). Clean
the filters if necessary.
Cleaning the filters should happen once every 2 years, or once every 1500 hour runtime.
1
Bottom filter
Image
R5914789 /00
UDX Bottom filter
2–5).
11
Advertisement
